Newsletter From REDT
6 May, 2013
Material Surface Measurement by Probe in Magic-7
Usually the surface measurement by touch is used when the engraving by the diamond tip is performed.
But the Magic-7 offers feature that allow user to select the method of measurement between probe and touch.
This feature is activated by pressing "X-" or "X+" button after engraving position selection is completed by the "START" button.
This feature can get rid of the small dot that is remained after the measurement by the touch.
Do the following steps or follow the above video.
1. Transmit engraving data to the machine, and designate the engraving area.
2. Press the "START" button to start engraving.
3. Then(within 2 seconds) press X-(for Probe) or X+(for Touch) button immediately as shown on the LCD screen of the machine.
This feature is applicable only with the Magic-7.
RED TECHNOLOGY TEL: 82-70-7011-0905 firstname.lastname@example.org
Copyright(c) 2005-2013 RED TECHNOLOGY. All rights reserved FAX: 82-42-673-0905
Best in CNC Technology